2005 Chrysler Sebring Conv "replace 3 cam oil" Questions

...3 and 4 cam journals, oil pump is driven off the end of camshaft, engine runs very rough and makes all kinds of noise when this happens, cure is a new engine. to check for broken cam shaft removed ...

cam to bind and break 3. If no pre-lube was used during install, cam will also bind and snap before oil can reach it. In any case, I would not use that cylinder head again unless extensive (expensive)

...Replace Caution: The magnetic timing wheels must not come in contact with magnets or any other strong magnetic field. This will destroy the timing wheels ability to correctly relay camshaft position ...

...3/8 or more play.Can i replace the cam and lifters. Determining what caused sudden slack in valves would be of concern to me, as in perhaps, changed oil brand, grade or filter incorrect? Most small ...

...cam 25Nm+70deg+70deg+ 30deg alot of after market gasket sets are the 25Nm and 3 lots of 60deg and the extra 10deg bolts are meant to be replaced (use once only) alot of bolts tend to start stretching ...

...3 cam rotations. depends on your vehicle. otherwise, i'd say you have a valve guide seal in need of replacement due to oil slippling past it. rings are the worst case scenario since you removed the ...

...3 or 4 seals, crank and cams. pan gasket valve cover gaskets love to leak because it is ignored. and some 0-rings on some engines. ive seen heads replaces and the mech didnt read the sealant steps in ...

replace cam (now Edelbrock) as cam used (Crane) on rebuild was soft and rounded of first 3 lobes at front of engine (for info this problem does apperar to have started after replacing cam and lifters)

...3 SECONDS AND DIE Have the vehicles oil pressure checked. If oil pressure is good then its the switch or the circuit. If oil pressure is not up to spec's then you have to replace the pump and there ...

3 minutes and starts to warm up. I took it to a shop and they measured pressure at the filter and said the oil pump is putting out 65psi at idle but no oil is getting to the lifters. Is there some oil