1994 Lexus LS 400 "remove radiator" Questions

remove bottom hose from radiator get hose and insert in radiator and let run and see how flow is,if clooged,go to autozone and tell them what is happening and they will get you what you need to unglog

...remove the bolt on the crankshaft? The crankshaft pulley actually came apart and the only part left is the piece of metal that the bolt goes through. Get a breaker bar and posision it against a ...

...remove the radiator to check the flow at the radiator shop.One thing you need to make sure the cooling fans are working as well if it is getting to temp and never coming on you need to check the fan ...

...radiator remove it and you will see the hose in the middle of the front of the engine remove the 2 bolts and be careful not to spill alot of your coolant or if it is hot to burn yourself once you get ...

Remove the radiator pressure cap from a cool radiator and insert a thermometer into the coolant. * Start the engine and let it warm up. Watch the thermometer and the surface of the coolant. * When the

...radiator hose does not get hot, then you either have no water in there or the thermostat is stuck closed. If you want to test it, remove the thermostat and put it in a pan of boiling water. If it ...

...remove/replace the water pump. Install the timing belt and isure that all the marks line up after you reset the tensioner. Rotate the engine clockwise 2 full turns and check all the timing marks. If ...

...radiator. Remove the cover and then loosen the screw to take the center air cover off from over the radiator. 2. While working your way to the right, you will notice there is another cover on the ...

...remove of the pump.. thanks. if it is the pulley that is loose and not due to bad bearings in pump i would recommend removing pump in order to properly torque nut because the last thing you need is ...

...RADIATOR INLET HOSE FROM INLET PIPE. REMOVE THE TIMING BELT FROM THE WATER PUMP PULLEY. REMOVE THE RIGHT SIDE IGNITION COIL.REMOVE THE WATER INLET HOUSING AND THERMOSTAT.REMOVE THE MOUNTING BOLTS AND ...