1999 Jeep Wrangler "crank position" Questions

Ad

Question about Jeep Wrangler

1 Answer

Crank Position Sensor Where is the Crank Position Sensor (CPS) located on a 92 jeep wrangler? wall5552: there were two engines used in 1992 Jeep Wranglers. A 2.5 liter and a 4.0 liter. HOWEVER>>

Ad

Question about Jeep Wrangler

3 Answers

crank position sensor, cam position sensor or other ignition components including the vehicle PCM, so it is a wide field of things that need looked at in order to narrow it down to the problem. Having

Ad

crank position sensor. If this goes out, when it gets hot, the sensor will think the crank/timing is in the wrong position. They did this to prevent engine damage in the event that your timing is off.

Question about Jeep Wrangler

1 Answer

crank position sensor to the computer should be checked first. Disconnecting and reconnecting the wiring connector may help. Without the right diagnostic equipment, it is difficult to determine if the

Question about Jeep Wrangler

1 Answer

Crank (shaft position) reference signal detected during engine cranking (starting). P 1391 =Intermittent Loss of either Camshaft Position Sensor or Crankshaft Position Sensor. Hav you attemtped the "3

Question about Jeep Wrangler

1 Answer

...THE BRAIN OR COMPUTER,STARTER RELY,AUTO SHUTDOWN RELY,NEW DISTRUBUTOR,NEW COIL,WIRE AND PLUGS,CRANK SENCOR TIRED OF GUESSING THANKS FOR YOUR HELP Take the distributor cap have someone crank the ...

...crank position sensor twice in one month problem continues i ve replaced the crank position sensor twice in one month. fixes the problem for a short time then it starts again. when it tring to shut ...

...four wires in harness have continuity. If your checking fuel pump voltage, check other wires while cranking that will be fuel pump voltage and will only have voltage while cranking, or 3 to 5 secon ...

Question about Jeep Wrangler

1 Answer

...crank time. b). Two engine start attempts prior to engine starting. c). Due to the ?TIP Start Feature? on automatic transmission equipped vehicles, once the ignition key / switch has been released ...

Question about Jeep Wrangler

1 Answer

crank position) sensor Probably start with changing the crank sensor. But keep in mind that the high charging system voltage may be causing the other electrical sensor problems. The voltage regulator

Not finding what you are looking for?
1999 Jeep Wrangler Logo

641 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Jeep Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

john h

Level 3 Expert

29494 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...