2004 Chrysler Sebring "short ground testing" Questions

...short to ground on the control circuit. Repair the short to ground and retest as needed. 2. If the solenoid doesn't click as it should, disconnect the EGR solenoid connector and connect a test light ...

...ground. Start by pulling all of the dome lights and sockets and test again. I use a 10 or 15 amp circuit breaker in place of the fuse, during diagnostics... Then I follow around the path of the wires ...

...ground wire off the battery and my test light hooked to it and stuck to the post I started pulling fuses till my test light went out and that was with the stop lamp fuse so what im wondering is where ...

...are on the same fuse. Any thoughts? probably have a bad ground to the dash cluster or the dimmer is ...

...short or loose connection 97 chrysler seabring 2 door hardtop v6 automatic. Radio cuts out when brakes are applied. all interieor systems affected.alt is new, alt light on, not charging. checked ...

...found out the root cause when my car shut off on me while is was driving it. I was lucky the short fried nothing. Instead of replacing the whole wire harness, which would have been expensive,

2003 sebring 2.4l ck engin light on code po340 can you help P0340 - Camshaft Position Sensor Circuit Malfunction This indicates that a problem was detected in the camshaft position sensor circuit. ...

...to run low in the reservoir... and will not leak if the vehicle hasn't been running. If driven shortly after cooling off from an overheat, the engine sometimes lets out a disturbing rattle when ...

...ground/short problem in the ignition circuit, or does the starter need to replaced because it is drawing too manuy amps? can I put a wire to jump the fuse to isolate the problem, then quickly ...

...to autozone and have them do a load test on it. I’m thinking that the battery may have a internal short. If the battery test ok check your cables and post for a good connection and clean them with