...2 screws hold it on.Here's where the blower motor is. I just change resistor in my dodge ,they are all in two places .One is in the housing around the heater blower which is under or behind the glove ...
change the brain box and wireing harness,and chech the weight ratio of the 2 motors if there close in weight,like 50 lbs or so than its good if its more than100 your going to have to beef up the front
change egr valve on my 1999 sebring convertable my car wont pass smog its showing code ps 401 or other wise a bad egr valve you'll find it at rear of motor near fire wall it will have a 6pin connecter
...Change oil and filter. Use a synthetic blend oil, add 1/2 pint of marvel mystery oil, and drive for a short time, 30 minutes or so. If knock continues, the damage is already happened. Use only ...
...2 weeks out of the month I drive my carr. Just recently I noticed this ticking/knocking sound in my motor. I notice it more when my car is warmed up and idleing, I thought it might be my valves, but ...
Question about Chrysler Sebring
...2. Are you sure all electrical connections are correct (and complete) after installing the Dodge engine in the Sebring? Yes , just because it is a different model Chrysler use the same engine in all ...
...change it in a 2005 chrysler sebring 2.7 liter. Thanks If you follow the top hose out of the radiator back to the engine, you will find the thermostat housing, kinda ball shaped, there are 2 bolts ...
2 weeks after the oil change, the problem would resurface. Ultimately changing the oil pressure sensor solved to problem. check the oil pressure with a gauge at operating temp do not drive the car!!!!
change 2 weeks ago, and check my oil religously, my oil level was full on the dipstick, so the original thought of enigine seizure went away. I tried to jump the car and still when I turned the key it
1,852 questions posted
Usually answered in minutes!
965 Questions
801 Questions
581 Questions
462 Questions
523 Questions
