2001 Chrysler Sebring "labor ball joints cost" Questions

Ad

Question about Chrysler Sebring

1 Answer

...hard one to tell u cause shops labor rates greatly across the country and even from shop to shop in same towns for cost i would make a couple calls to few shops and get a ball park figure for your ...

Ad

Question about Chrysler Sebring

2 Answers

...ball set will be $40.00. The labor price for the lower replacement procedure will be $165.00 NOTE_ Land Rover recommends to replace the upper and lower, in this situation. Total cost, if you chose to ...

Ad

...THE COST 100.00 EACH NOT INCLUDING LABOR. Lower Ball Joints Moog K80014 ----$35.79 each Go to Rock Auto.Com Bottom ones are common on Expedition Have to ask a shop about labor This is just a chat ...

Question about Chrysler Sebring

1 Answer

...ball joint repair cost with labor Labor rates are different in other locations. the average labor rate where I am is 68.88 an hour. Your ball joint replacement says it takes 2.3 hours to do. the ball ...

...ball joints and tie rods on my 2000 lincoln ls v-8 cost $3,000.00 seems rather costly they are front suspension pieces, and yes it is costly, but its not just the parts, there's labor also, and ...

...ball joints on a 2 wheel drive Ford ranger. Is that amount reasonable? that sounds pretty high, I had those replaced on my 99 ranger XLT and it only cost me $400.oo, in Naples, FL. Id definately shop ...

...much would it cost to take it to the mechanic to replace the ball joints a ball joint kit of four usually run around $500 - $600. plus $350- 500 for labor. You should try it yourself its not to ...

ball joint poped in my 1994 Mercury Cougar, 2 door coupe. How do I repair, and estimate cost. replace the lower control arm. control arm costs 60.00-90.00 bucks and 200.00 apprx. on labor. do you have

...out, too. Much easier to do, so the cost of the part might be offset by the savings in labor. Just a few nuts and bolts and getting the ball joint to release from the knuckle with a few hammer

Question about Chrysler Sebring

1 Answer

...a little more. If you have the ball joints done at a shop several hundred plus you pay double for parts. Some shops will install parts that you buy thus you pay for the labor. I hope this

Not finding what you are looking for?
2001 Chrysler Sebring Logo

1,238 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Chrysler Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

john h

Level 3 Expert

29494 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...