...oil level ok oil light on and off in the mornings oil level ok If the level is OK, either the oil pressure sensor is bad, or the pump is failing. It's possible the oil pump is failing or partially ...
...oil level. if oil level okay more likely oil pump has failed or engine bearings worn out or engine oil diluted with antifreeze or gasoline causing viscosity oil to be too thin.if oil and filter ...
...oil level (ok) had recent oil change and engine flush....what might be causing this problem please. Your oil sensor may be faulty, or your may have a leak since you said the fluid level is
will oil pressure sensor stop the car from starting on 03 PT c a lot of cars have this sensor if oil is to low it will not run to keep from runing the engine ckeck the oil level make sure it is full.
...oil level in the crankcase but rather oil pressure. The oil pressure switch/sensor is located on the rear of the engine block above the right axle I believe. Unless you have engine noise or suspect ...
...oil level and its normal not at max but not at min. By any chance did this start after an oil service. Could be the wrong oil. But my first guess is the wire at the sensor may be loose or the sensor ...
oil level and it was fine. No leaks on the ground. Car will not turn over when trying to start! P0340 is "Camshaft Position Sensor Circuit Malfunction". This would make sense and is a relatively
Question about Chrysler PT Cruiser
...oil level, if the oi level is good. Then it's a good chance that the oil pressure sensor may have gone bad and needs to be replaced as long as there is no damaging noise coming from the engine. It is ...
1,827 questions posted
Usually answered in minutes!
1,198 Questions
1,007 Questions
816 Questions
677 Questions
582 Questions
