...I change it? its the o2 sensor behind motor on top of exhaust manifold. very easy to get to. the Upstream O2 sensor is bolted into the top of the exhaust manifold at the back of the eng easy to ...
...sensor to manifold. Tighten screws. Connect the electrical connector to the sensor. Connect the negative battery cable Install the air cleaner cover. Fig. ...
where is the knock sensor located on 2005 pt crusier engine block cant find it Its directly below the intake manifold, you may need to remove manifold to see it.
...Manifold Gasket. 9InspectCooling Fan Switch - RaditorFaulty Raditor Cooling Fan Sensor/Switch. 9InspectWater PumpLeaking Water Pump. 9InspectRaditor Fan MotorFaulty Raditor Cooling Fan Motor. ...
...a code error of P0325. Thanks Chris 2 knock sensors are used..small black plastic sensor bolted into engine block below each exhaust manifold..be careful not to over torque bolts upon ...
...SENSOR INLET MANIFOLD GASKETS NOTHING SHOWS UP WHEN PLUGGED INTO COMPUTER ALSO CHANGED LAMBA SENSOR ENGINE DONE 116000 MILES COULD ECU NEED PROGRAMMED WOULD GREATLY APPRECIATE ANY HELP How about the ...
sensor for 04 pt cruiser Hi, Beneath the exhaust manifold on the backside of the engine compartment to the right and slightly above the oil filter. you must reach it from beneath the engine by putting
...sensor is located behind motor and manifold and need an o2 senor socket and racket plus extension to remove and then your downstream 02 sensor is on the side of Cat convertor (drive side)and same ...
...manifold, injectors, electrical connector to the cam sensor, just get to the bolts to remove the head. If your around 100000 miles replace all timing components, thermostat and radiator cooling fan ...
where is the oxygen sensor on Chrysler pt cruiser There are 2 oxygen sensors located in the exhaust system One around the exhaust manifold and the other behind the catalytic converter
1,827 questions posted
Usually answered in minutes!
1,198 Questions
1,007 Questions
816 Questions
677 Questions
582 Questions