2001 Chrysler Concorde "manifold" Questions

...to replace this? I already have the part, but it looks like I have to remove the upper intake manifold. You don't have to remove the upper intake lossen all the manifold bolts and lift the ...

how much torque is needed for the bolts on the intake manifold on a 3.3 litre engine in a 1999 crhsler concorde Intake manifold & fuel injector 200 in lbs, plenum 250 in lbs. Hope this helps, Rick

where is the manifold air pressure sensor Left (drivers) side of upper intake manifold.

...bank 1 sensor 1 As you look under the hood, bank 1 sensor 1 is the first Oxygen Sensor off the manifold on the left side of the engine (manifold). See diagram below --- Hope this helps. ...

...96 corolla, it is on the "clean air" side of the filter box just before the pipe that leads to the manifold. The only thing i can think to compare the apperence of the sensor to would be something ...

...your iac. An EGR Valve is an Exhaust Gas Recirculation valve that is located on the intale manifold. Has vacuum line attached to top of it going to the plenum/intake vacuum connection on ...

...can cause by a lot of components. Dirty air filter Dirty injectors + o-rings Vacuum leak at intake manifold and vacuum hose. Bad Idle Air Control Motor (IAC) Low compression (170 psi + is OK) Start ...

procedure to r&r intake manifold gaskets http://www.autozone.com/shopping/repairGuide.htm?pageId=0900c1528006aa32 REMOVE THE RETAINING BOLTS FROM THE INJECTOR RAILS (USUALLY 4 WITH 10MM HEADS), THEN ...

...sensor and new wire connector to crankshaft sensor. There is a gray connector behind the intake manifold that is disconnected and i canr find where it goes. Thanks. May be a small vacumn ...

...Circuit poor electrical connection When Detected? Engine running and Engine Control Module detected Manifold Absolute Pressure (MAP) sensor Voltage less than expected. Solution: Locate MAP sensor and ...