1999 Chrysler Sebring "ignition trigger fuel pump relay" Questions

...ignition looking for wear and conductivity. I had a similar problem with another car. Check the fuel pump relay. it could be bad. Hi, Sebring 96 convertible - same simptoms as described above - no ...

...shut off and the computer kills the trigger signal to the relay dear friend its clear that when the ignition is turned off the live circuite goes to fuel pump will be disconnected by the ignition

...fuel pump relay. When the ignition switch is first turned ON, the PCM energizes the fuel pump relay, which applies power to the fuel pump. The PCM enables the fuel pump relay as long as the engine is ...

...ignition coil, injectors and those parts of the power module.  This causes the engine to shut down. The logic module monitors the relay driver.  If it senses that the relay driver is ...

ignition key being used to start the vehicle. This should also trigger the security light to be flashing on the instrument cluster as well. Look for that rapidly flashing security light to see if this

...fuel pump quit then worked once when hot-wired with 12 volts. fuse and relay is good. The wire should not be hot until the relay is triggered. The relay does not get triggered until the ignition key ...

...fuel pump with ignition on. Replaced fuel pump and filter.Turn ignition on- pump did not run.Jumped the fuel pump at the pump relay.Pump worked and pressurized fuel rail. Still no start. Checked OSD ...

...ignition on. Its the negative wire thats being switched by a relay that is triggered by an electronic pulse censor. This censor works of a toothed gear on the front pulley. This censor also triggers ...

...ignition is on, you can usually bypass the relay with a wire across the N/O normally open terminals of the relay, but be careful not to short the feed to the coil of the relay, usually terminal 30 on ...

ignition seems to be in good conditions the fuel pump is triggered by the engines oil pressure switch upon starting when oil pressure reaches normal psi the relay takes over powering the fuel pump you