1998 Chrysler Town & Country "advanc auto battery wouldnt start" Questions

...battery, had alternator replaced cause the old one tested bad, replaced cerpintine belt cause it was loose and had many cracks, there is more power but van wont turn over. what do you think? Sounds ...

battery. Any major auto parts dealer( Advance, Autozone, NAPA, Oriellys,etc.) can test this at no charge. Also use a voltmeter to test the alternator output. Most alternators put out between 13.5-13.8

...battery as not being the issue. Then check your alternator. They can test these at any local Napa or advanced auto parts for free. Your alternator has likely failed. Remove the alternator and have it ...

... and taking car to local Autozone, Advance or any good auto parts store and have them load test your battery, that'll confirm or not. While there have them test your charging system - they do both ...

...WOULDNT START WHEN HOT, NOW IT JUST WONT START. CHANGED THE STARTER,IGNITION SWITCH,AND THE IGNITION COIL. GOT POWER TO STARTER AND THE REST OF THE CAR BUT WONT KICK OVER.IM NOT GETTING NOTHING BUT A ...

auto parts store and have them do a charging system test and to load test your battery. They offer this service for FREE Another Note: When was timing belt last replaced? If it's a 325 of that year it

...battery. The truck will start fine but when I take the hot wire off the batery the truck dies. I tried checking the wireing to the alternater and the starter, it all seemed fine. When you touch the ...

...tight and you pulleys spins freely. If that is all good take it to the advance auto parts and have them test the battery, the alternator, starter, and a drain test on battery. This is a free

...battery is low but its not. then it will turn fast and almost start then it will do it again. Is it possible that something is holding it back in the motor. I am going to mess around with it tomarrow ...

...auto parts diagnosed 58 acc on the battery and alternator needed to be changed. I'd changed the alternator but after couple hours drive srs indicator went on rpm went "0" temperature ...