...and still get the P0122 code, it could be a short in the wiring or a problem with your Powertrain Control Module. Other names for the PCM is ECM and ECU. Engine Control Module and Engine Control ...
code is still there. Manifested symptoms are: engine dies or tries to die when gas pedal is immediately released coughing and sputtering while driving particularly under load. What else could it be? I
Question about Chrysler Sebring
...engine as well as other Emissions System Components. Code P0122 triggers when the Throttle/Pedal Sensor/Switch "A" Circuit has low output Symptoms Check Engine Light will illuminate In many cases, no ...
engine code p0122 keeps coming on 3.3 l engine P0122 ACURA - Throttle Position Sensor 'A' Circuit Low Voltage.Possible causes- Faulty throttle position sensor. - Throttle position sensor harness is ...
...engine light comes off and on and the Jeep is throwing code # P0122....What is the code for?? P0122 (M)Accelerator Position Sensor (APPS) Signal Voltage Too LowAPPS voltage input below the minimum ...
...p0122 p2101 engine skips on limp mode engine light on wrench lite on anti skid light on P0122 throttle/pedal position sensor/switch A circuit low input P0223 throttle/pedal position sensor/switch B ...
engine light came on trouble shooting code is P 0122 Code P0122 is a TPS (Throttle Position Sensor) sensor out of range. The operating range of the TPS is about .5 to 4.8 volts. .5 at idle 2.5 at half
Question about Chrysler Sebring
...engine will start. Precision Tune Auto Care diagnosed with computer having CODE #po122. The Technician Comment was as follows: After clearing code, code does return this is a P.C.M. issue and will ...
engine turns over, but will not run trouble codes found were PO442, PO122, PO342 P0342 Camshaft Position Sensor Circuit Low Input P0122 Code - Throttle Position Sensor/Switch A Circuit Low Inputith a ...
code will not help the car start if you have a TPS (throttle position sensor) problem. If the TPS is far enough out of position or has a faulty electrical connection then the proper voltage by the TPS
882 questions posted
Usually answered in minutes!
1,173 Questions
965 Questions
801 Questions
462 Questions
523 Questions