1997 Chrysler Sebring "rear seat convertible" Questions

...have to help it manually. Some said i need to pull my rear seats to check for a hydrulic leak, and add fluid. push hard in at the base of the seat then lift up. Why not get to the pump from the

...rear wheel hub seems to be behind the seat or rear back panel.. its in the trunk area over the wheel. you have to remove the trunk liner panel and then you can access the strut mounting ...

...sloshing yes there are holes. the holes are on both sides of the back window. climb in back seat and look under the back window  on the side rear quarter panel inside you will one on each ...

...rear seat back 04 Chrysler Sebring Convertible. Trying to get to the pump for convertible top. Removed back seat bottom. Located the two bolts to remove the rear seat back rest. These bolts do not ...

rear seat cushion, seat back and inner quarter trim panels. Pull up sharply on the seat cushion at the front about midway between the middle of the seat and the outside edges. The seat back is held in

where are the hydrolic rams located on the 99 sebring convertible top in the side panels beside the rear seat

rear seat to budge. There is no gearbox. A motor runs a pump which moves the cylinders. You are probably low on fluid. Behind the rear seat is your motor/pump/reservoir combination. With the top down,

...REAR SEAT CUSHION.YOU WILL SEE ACCESS COVER ON TOP FUEL PUMP.REMOVE ACCESS COVER YOU WILL SEE FUEL PUMP MODULE. SEBRING CONVERTIBLE YOU HAVE TO REMOVE FUEL TANK TO REMOVE FUEL PUMP. In the fuel ...

rear seat is your motor/pump/reservoir combination. With the top down, fill the reservoir to overflowing with ATF. Cycle the system a few times and repeat. Do this till the reservoir will take no more

...rear seat. The bottom cushion of the rear seat would pop out, there will be clamps at either side of the outer edge of the seat.  The rear seat back, can be removed by removing the seat belt ...