1997 Chrysler Cirrus "spark" Questions

...morning tried to start the car it turns over just fine. acts as if it's not getting any fuel or spark. I checked all the fuses they are good, I listen to the fuel pump and i can hear it whirl

Car turns over but wont start. Changed the distributor and the cap, ignition module. Tried to get spark from plug connector in the wire and there isnt one, when i grounded it to the chassis. What the ...

spark plug location The spark plugs are located in the holes on the valve cover. If this is a v6 engine you will need to remove the plenum to remove the rear bank spark plugs.

no spark. new distributor and wires. new crank sensor 8 volts to the distritubor. signal wire good. The 97 Chrysler should have onboard computer diagnostics. If you aren't getting a spark you should ...

1999 chrysler cirrus lxi car wont start replaced distributor and put new plugs and wires and got spark and fuel pressure. Is that my timing belt? Car not starting or turning over indicates towards ...

car will not start after changing crank sensor, battery, spark plugs and fuel filter I'm assuming that it did not start before replacing all of these things. The value of reading out any codes with a ...

...P0301 P0300 Per Google search: P0301 - Cylinder #1 misfireP0300 - Random cylinder misfireCould be spark plugs, wires, etc. I'd start with the spark plugs if you know they haven't been ...

...through a car wash and when my car got wet underneath it died. It's kicking over but not getting a spark.. I know 1 spark plug is bad but could that 1 spark plug be the issue? Or What could it be? I ...

I want to change my spark plugs How are the spark plugs and wires changed on a 1996 cirrus. is it a V6 or 4 cyl? V6 is quite complex, have to remove the upper intake to get at them

...help asap any help would be greatly appreciated Check for a fuse for the injectors.  Pull a sparkplug or two after cranking the car over and see if they are wet with gas, as they should ...