Question about Chrysler Town & Country
...motor to the lower half of the HVAC housing. Gently flex the recirculation air door downward to gain access to remove the blower motor from the HVAC housing. NOTE: To aid in installation, note the ...
Question about Chrysler Town & Country
...terminal. Connect the B+ wire and tighten the retaining nut to 90 inch lbs. (10 Nm). Lower the vehicle. Connect the negative battery cable. Verify starter motor operation. Posting pics on next
...terminal. Connect the B+ wire and tighten the retaining nut to 90 inch lbs. (10 Nm). Lower the vehicle. Connect the negative battery cable. Verify starter motor operation. Good luck and hope this ...
Question about Chrysler Town & Country
...to the front washer pump. Disconnect the electrical body harness connectors to the washer pump motors and the fluid level sensor. Slide the red lock on the connector to the release position,
lower edge of glove box. (open). you need to replace the blower motor resister located by the blower motor on the heater box. The 'blower motor resistor' listed above is the failing component. Its not
...motor mounts, suspension bushings, check for any motor oil leaks which could occur from any leaking gaskets. It is also a good idea to have change your spark plugs at this point as well. Normal spark ...
...motor is probably bad. If the switch is not working, check the ground connection to the switch. Pull the cup holder out, then remove the small plastic trim piece between the cup holder and the HVAC ...
...motor now its still a cross line i have to get past before the belt is install any suggestions REMOVAL Remove the following components. The engine mounting bracket lower nut. The engine mounting ...
...MOUNT FROM MOTOR, JACK THE MOTOR UP TO CLEAR MOTOR MOUNT, AND UNBOLT IT FROM THE FRAME! REPLACE IT, BOLT THE MOUNT TO THE FRAME FIRST, THEN LOWER THE MOTOR BACK INTO THE MOUNT, AND REBOLT THE
...mount bolts, raise motor off the mount, replace mount, lower motor back into position, resecure motor mount bolts, and your done. usually just the rubber gets worn out on those things, pretty
788 questions posted
Usually answered in minutes!
1,229 Questions
1,289 Questions
1,079 Questions
746 Questions
666 Questions