1995 Chrysler LeBaron "loose power steering pulley mean" Questions

power steering pump1/4 inch check all pullys for play You need to check to make sure it is in fact the correct belt. You also need to check the tensioner. If the tensioner is bad it's not going to put

power steering pump and pulley. I replaced both 2x. Rented the kit thingy to tighten the parts, but for the 3rd time my pulley is cracked. Can you help me with finding out whats going wrong here? When

...power steering pump,A/C compressor and alternator.) If component play, you could have loose bolts causing wobble. If pulley play, could be bad bearing in component which would need replaced. Pay ...

...power steering lines and the inner tie-rod boots if the fluid is low. If the fluid is ok, no leaks and the belt is tight the pump may be going or the steering rack could be binding which means ...

...the pulleys and other components (power steering, AC compressor, alternator, etc) to make sure they all turn by hand. While a whine is normally a loose belt, it could also be a bearing that is

...loose -check power steering fluid level if low will cause binding and can cause belt to slip if alternator going bad can cause same or idler[tension] pulley going can cause slippage but most likely ...

loose all power after a short(few miles ) distance. And you will loose power steering , amking it harder to turn. timing belt/tensioner should be replaced at 80k/6years.regardless of makers suggestion

...power steering depending on engine type and size. Have the belt replaced before driving car as if you overheat the engine you could end up with major engine damage.The belt on the 2.4 litre engine is ...

...loose and needs a new one, or if it is one of the pulleys for definitely, it sounds like the power steering pump or the air-con pump just depends on what side of the engine it is, check belt first ...

...power steering pump. Unbolt the hydraulic line brackets from the upper timing cover and move the pump out of the work area without disconnecting the hydraulic lines. Disconnect and remove the starter ...