breaks my break lights are stuck on need to locate switch under break pedal look up at the pedal its at the end their somewhere
...my 2000 chrysler cirrus not have brake lights? have changed fuses and bulbs I would say it is your break switch. It is located under the dash, above your gas and break pedal. This will solve your ...
trying to replace the bulb for brake light but not sure how to remove old bulb without breaking it Depending on your years they will twist out or pull out. And about half the times they break. If it ...
My breaks wont work after changing the front rotars, calipars and pads. I bleed all four breaks starting with the back passenger side then back drivers side then front passenger side then front ...
steering seems to lock when turning left...it takes both hands to recover to straight driving your power steering pump could be going bad. if so replace it or it could freeze up and break a belt.
my 1999 chrysler cirrus no break light. bob is good, SW is good, no power on SW Run a new wire to the switch from the fuse box IGN lug
the medhanic said my surpentine belt has cracks a few cracks are ok a lot are not keep in mind if it breaks your walking
can a wheel bearing break they can seize up and possibly lose bearings ,but should not fall apart ....as the axle will hold it together.
only 2 breaks w ork one front one back only 2 breaks w ork one front one back front brake problems can be sticky/seized caliper pistons due to fact thatbrake fluid absorbes water which causes the ...
what is proper way to take off drivers side door panel without breaking any of the clips so i can replace the window switch Remove the screws at the door handle arm rest and maybe some on the bottom ...
238 questions posted
Usually answered in minutes!
391 Questions
242 Questions
244 Questions
193 Questions
124 Questions