...heat Start searching for a vacuum leak. The dash switch operates a vacuum assembly - but if the line is cracked, it "door" will not change position. Check operation of heater coolant control valve, ...
pump motor 7 30A* Powertrain Control Module (PCM) 8 20A* Power door locks, Remote entry 9 - Not used 10 - Not used 11 50A** Starter relay, Ignition switch 13 20A* 4x4 Motor 14 - Not used 15 - Not used
Remote Entry Module, Cell Phone, Clock, GEM Module 9 ? Not Used 10 ? Not Used 11 30A Front Washer Pump Relay, Wiper Run/Park Relay, Wiper Hi/LO Relay, Windshield Wiper Motor, Rear Washer Pump Relay 12
...heat, shut off to fill with gas, and would not restart. After sitting in shade for about an hour (jump did no good battery fine) it restarted and made it home and then died again. Helpful mechanic ...
...Pump Relay- 11 for Heater and A/C Control, RH and LH Outside Rearview Mirrors- 12 for Hazard Warning Switch, Instrument Cluster, Data Link Connector (DLC), Stoplamp Switch, Gage Cluster, Heater and ...
Question about Chrysler LHS
...pump reset button in the cargo area, that looked to be in the ON position (ie I can push that button any further down) DOES not start, am I missing any thing , pls advise and as always thanks for the ...
...pump is faulty or worn crank and or rod bearings A plugged collant gallery may cause this problem too There is a good chance that your have a intake manifold gasket failure and your losing coolant ...
...remote battery under hood on the left side, I have located the positive cable connection, and the manual states the negative cable connection is near the power steering pump. But my question/problem ...
...Pump, Alarm System * 3 - 10 Amp Courtesy Lights, Oil Level Sensor * 4 - Not Used (1993-95) * 4 - 10 Amp (1996) Electronic Start Inhibitor (Immobilizer) * 5 - 30 Amp ECC Blower (Speed 4) * 6 - 25 ...
219 questions posted
Usually answered in minutes!
229 Questions
216 Questions
228 Questions
195 Questions
120 Questions