1994 Chrysler Concorde "cam sensor" Questions

...cam sensor. so the cam and crank sensors were replaced. tried to start the car still wouldnt turn over. unpluged the cam sensor and tried to start it again and it WORKS. so right now my c ar is ...

cam sensor keeps coming up on the scanner Like ALL OBD Codes-- they have nothing to do with the need to replace any parts You need to have the test equip & knowledge to find out why-- what is most

or something to show? the cam sensor is located on top of the engine in the front of the left side valve cover. the crank sensor is located on the right side of the engine block just above the starter

...in it wont start. you replaced cam? or cam shaft sensor? if u just replaced camshaft sensor. its probly the timing chain. it slipped and now u need to retime the engine after u install new timing ...

...Cam pos. Sensor and Coil block Try the crank sensor this is the sensor most likely to cause this not the cam sensor. To get to the crank sensor you will have to jack up the passager side of the car ...

cam sensor .ended up being a cracked flexplate that shifted enough it was screwing with crankshaft sensor.the sbec(brain box) was going nuts trying to figure out why cam/crank signals didnt jive so it

...sensor and cam sensor twice and still throws cam and crank code any one run into this??? What's the code ? P0016 Crank/Camshaft Mis-align/sync. How many miles on the vehicle ? Ever have timing chains ...

...cam sensor defective, timingbelt/out of trime, cylinder misfire...also another code said cylnder 5 missfire, also code P0340 cam sensor or timing whats the chance of it ust being the coil for #5, how ...

...cam position sensor circuit malfunction, but it is not the cam sensor. Where can I look for the problem? did u replace the cam sensor a code like that tells u what it is should check the wiring ...

...the cam sensor? Also if it does start after unplugging the cam sensor, don't drive it. Post back. my 98 concorde wont start if i unpluge the cam sencore it starts but for about 30 sec please ...