1995 Suzuki Sidekick "blown fuse heater motor high" Questions

...blown fuse. 2: bad switch (see link, below for how to fix THIS switch.) 3: bad blower motor. there are 2 ways to find it, not guessing... A: use a voltmeter, Got 12vdc to motor on fan? no ? then got ...

...blown the fuse. DO: check fuse, then blower motor. Pricing: new blower motor: Duralast PM270 $43.99 new heater control switch: Duralast SW229 $46.99 (without A/C). I'd expect your blower resistor to ...

...fuse blown, (always first, for the end of time) 2: controls bad. 3: blower bad. 4: wire to any of the above, bad. (not conducting or shorted) all cars,. some newer cars a computer runs this but is #2 ...

blown fuse for it would'nt be your answer. a blown fuse,no blower at all.the switch that turns your blower from lowest to highest is bad and you'll need that panel to replace it. autozone,advance auto

...please. THE WINDSHIELD WASHER COULD BE A BLOWN FUSE OR A BAD WASHER MOTOR. THE HEATER BLOWER IS MOST LIKELY A BAD BLOWER MOTOR RESISTOR. THE RESISTOR IS PROBABLY UNDER THE DASH NEAR THE BLOWER

fuse blown/ pin2, 0vdc if not the controller is malf''ing control switch not grounding this point if all that passes the blower resistor block is bad, and super common. but on high blower works ok? as

fuse is blown replace fuse, if the speed control only works on high, the blower motor resistor needs replacing. It is on passenger side under glove box in close proximity to the blower motor. The fuse

...check the fuse. If that is good then more than likely the blower motor resistor pack is defective. It can be the blower motor itself but highly unlikely on an 04 model. I would bet it is a blown

...heater. I have checked all the fuses and they are not blown??? If blower only works on high speed I would say blower motor resistor but if it does not work at all I would suspect blower motor. Make ...

...fuse for blower motor should be labeled. if it is blown most likely bad blower motor. if it is not blown u still may have a stuck blower motor but u have to chk for power at b.m. connector 1. Back ...