1998 Plymouth Voyager "plug wire resistance reading" Questions

...to Autozone and the diagnostics said the engine was misfiring randomly. Cylinder 2 and 6. Replaced plugs and wires and had code reset. A couple of days later light came on again went back to

...low resistance, and that wire should be replaced.Read more: How to Test a Spark Plug Wire on a Car | ...

plug wire using a suitable spark plug tester. Ground the companion cylinder spark plug wire of each cylinder when it is tested. If a strong bright blue spark is present on all of the cylinders, remove

...voltage for the coil. Need to unplug the electrical connection not the plug wire and measure the resistance there and see if you have the 9 ohms of resistance. If you do not then replace the

plug wires and boots? you can test the wire with an automotive electrical wiring instrument that provide a reading on the face of the instrument. Remove the wire totally (one at time, putting one back

...Resistance in your plug wires and plugs will burn a hole through the rotor button take it off and flip it upside down to check Or maybe the cwenter of the rotor under the metal tab is burned through ...

Surprisingly, a coil with high resistance may still fire the spark plug, but the voltage produced will be higher because the current must jump the open wiring in addition to jumping the spark plug gap

...coilpack so I know it not that Either the plug wires are worn or the plugs themselves. What are your resistance readings on the coil packs & ignition wires? What condition are the spark plugs

wire running to it. to check sending unit in the tank, locate the closest wiring harness plug (in the trunk/or under car) and disconnect then check gauge reading,remember ignition must be on. try that

...no fuel in the tank the resistance should only read around +- 5 also there is a plug just in front of the tank where the pump assembly plugs into you can check resistance there instead of dropping ...