1998 Plymouth Grand Voyager "not start turn" Questions

prolock starter kill can become defective and prevent your car from starting. or it can be your ignition switch. I had a defective ignition switch and the van 's fuel pump would turn on but no start..

...start. Turn switch off for a couple of seconds, try again, and it starts right up. It has also started making a kind of whirring noise frome the front end, when driving. My husband checked the ...

This morning when I started my '98 Voyager. It started for about five seconds then turned off. This happened three times. Started it one more time and revved the engine. Same thing, five seconds then ...

...start you car,turn your air off locate your compressor and you will notice the clutch is not turning.keep watching and have someone turn the air on you should see the clutch kick in and start ...

...start(turn over) just the dash lights come on. started once and died got it started again ran for 4 seconds and died again, now will not turn over. did you check your battery charge, try a new one, ...

...start it next day, turned over then died. can smell fuel when trying to turn it over but it still wont fire. hoping its not fuel pump going out but not looking good. any suggestions? i can tell you ...

my 1998 grand voyager wont start the fuse keep blowing when you try to start the van. what could be the problem? a fuse does what ? it protects circuit from over heating and burning all the wire. and ...

start. i turn the car and listen for the fuel pump to come on it came on for about 2 seconds and turn off it that normal? the fuel pump is only designed to run until it reaches a preset pressure. once

TURN KEY TO START. ANY SUGGESTIONS WOULD BE GREATLY APPRECIATED! You have a shorted engine harness, this is not common but it does happen, heat and engine movement cause damage to the harness, this is

have a 1994 plymouth grand voyager driving down the road it just quit about 2 hours later it started back up worked 1 more time then would not start again turns over but will not start crank shaft ...