1999 Jeep Cherokee "isuzu rodeo clutch problems" Questions

...Isuzu Rodeo to turn on occasionally? If the compressor is engaging when it should not be, the problem could be the compressor clutch or a faulty relay. The compressor normally runs in defrost as well ...

isuzu rodeo car will not run in drive will run in reverse ***For Automatic Transmissions ONLY*** See if the Check Transmission/Check Engine light is on. If so, the likely cause is a sensor failure. If

...isuzu rodeo and i just replaced the clutch. now the car will not come out of the gear it is in and it will not shift. what did i do wrong? Is the clutch linkage adjusted so that there is enough ...

Rodeo clutch. While bleeding never got pressure in pedal, have fluid leaking need to know how the lines run around engine to find leak. Did you bench bleed the master or slave cylinder ? Is Your Brake

isuzu rodeo wont go into gear the gears go in fine if the car is off but once its on i cant get it into gears the clutch feels fine I had the same problem and my fluid was fine! First try to bleed it

...Isuzu Rodeo in which the clutch pedal went to the floor & stayed there. Upon inspection, the clutch master cylinder was empty on fluid. I filled the reservoir & bleed the clutch master slave ...

...ISUZU RODEO CLUTCH PROBLEM Replaced clutch, master and slave, bleed clutch and works fine for a day or two then won't go into gear unless stopped and engine turned off. Figure air is getting in ...

...Isuzu Rodeo when you push down on the clutch pedal to start it cranks and sputters, but I can get it start but when I push the clutch pedal down it will die. I can play around and get it to run for a ...

...Isuzu Rodeo 3.2L year 94 how do I check if the clutch for the radiator fan is good or not Your fan should turn freely when cold and begin to lock up and spin faster when engine gets hot. If fan does ...

...Isuzu Trooper 1995, the gears will not change but car starts and drives in this one gear. The clutch is fine, doesn't stick or anything. What might the problem be? The pressure plate to the clutch is ...