2004 Isuzu Ascender "popped light bulb" Questions

...light bulb on 2004 ascender Open the hatch. look at the panel, you will notice the top comes down over the bottom. It just pops off. Pop the sides first, then the top of it. You'll see the bulb ...

...light bulb attachment screws into the back. Unscrew the attachment and remove the bulb. When you replace with the new bulb be careful to not touch the bulb with your bare hands as a chemical reaction ...

bulb you mentioned. wonder if there's a relay associated to this circuit, check for short if this is the case. remove all the light bulbs [of course - the dash may not be necessary (it's a PITA) &

everytime you turn them on. Where can we find the park lamp relay? Check light bulbs or tow light harness for short Sometime an incorrect bulb cause a fuse to pop make sure corrct bulbs are installed

in the ignition the buzzer works. Probably a blown bulb or popped fuse. Sometimes the back of the dome light can ground against the underside of the roof, popping the fuse. Start by replacing the bulb

No headlights at all. No dip beam,no main beam, all other lights ok. Lights pop up ok. Bulbs ok. the headlight switch is good because the lights pop up. check the ground for the headlight bulbs.

...light cover and the surroundingframe. The tip should be on the side of the hinge, about 1/4" away fromeither corner. The cover will pop right out. Then Use your screwdriver to popout the light

light bulb? how to replace brake light bulb in a 2003 mazda mpv? If similar to 2002 MPV, you detach the whole side light module, then pop out the bulb-socket, then you can replace the bulb. You need a

light bulb. Inside trunk, remove two black plastic nuts holding carpet liner in place on side where bulb is burnt out. Pull back carpet, use a flat screwdriver to pop out the wiring. Remove three nuts

...dome light on chevy model. Please click on the link below:-------- http://technoanswers.blogspot.com/2011/03/how-to-replace-dome-light-bulb-on.html -------------- This should