...3. Connect the wire harness connector (1) to the blower motor resistor and engage the wire harness connector locking tab. 4. Install the glove box (Refer to 23 - BODY/INSTRUMENT PANEL/GLOVE BOX - ...
...3. Connect the wire harness connector to the resistor block. 4. Push in the lock on the blower motor resistor wire harness connecgtor to lock the connector latch. 5. Install the glove box. 6. ...
...wire harness connector to the blower motor resistor or controller. 3. Plug in the connector from the blower motor resistor or controller to the blower motor. 4. Connect the batten' negative cable. ...
Question about Pontiac Cars & Trucks
...3) that secure the blower motor to the vehicle. Pull the blower motor from the vehicle. Step 4: Disconnect the wiring harness (1) mounted just to the LEFT of the resistor. Step 5: Loosen and remove ...
3. If you have power on fuse 7 with the key on, then check for power at the blower motor on the blue white wire. If no power on it you have a break in the wire between the fuse and the blower. 4. Next
wire harness back through the cowl plenum access hole. (3) Install and tighten the two screws that secure the front blower motor resistor to the cowl plenum panel. Tighten the mounting screws to 2.2 N
Question about GMC Cars & Trucks
...3 Repair the short to the voltage in CKT 65 (PPL) wire. Is the repair complete? -- Go to HVAC Blower Controls System Check -- 4 Turn the blower switch to the LOW position. Connect a test lamp between ...
Question about Isuzu Pickup
...3, not on 4; relay or resistor? Remove blower motor resistor and check to see if it discolored or melted. if so then replace blower motor resistor, also blower motor speeds 1-4 go through ...
...look for? The blower motor is fed through a fan speed control whih is an array of 2 or 3 resistors. That thing is normally screwed onto the blower housing with 2 screws only. Remove it and replace
wire harness connector to the blower motor resistor or controller. 3. Plug in the connector from the blower motor resistor or controller to the blower motor. 4. Connect the batten' negative cable.
256 questions posted
Usually answered in minutes!
142 Questions
121 Questions
102 Questions
92 Questions
69 Questions