2003 Chrysler PT Cruiser "engine idle down filter disconnected" Questions

...engine light came on, then the car started running extremely rough. It became so bad, I had to pull over. Sitting idle, it seems to idle a little rough, but when I gas it gas, it would rev up the die ...

Engine stalls cold or RPM fluctuates at idle up and down or dies near idle. This problem is commonly caused by a dirty automatic idle speed control valve and throttle valve but always run a OBD2 fault

...Engine running rough idle and under load,stalls at idle going down highway. Check fuel pressure,changed fuel filter,plug wires,coil pack,ICM. Checked cam,crank sensor. Disconnected battery to clear ...

...idle, misfire during acceleration- blinking check engine light. Vehicle mileage is 194,000 When vehicle is at a stop or running idle, to prevent cutting out driver puts in neutral gear- seems to run ...

...in the idle of the engine. then reconnect the plug to the iac valve and turn on the a/c and listen for the engine idle speed to change. If not then replace the iac valve. Hope this will help

shop says it will take some time for the engine to relearn the right idle. Is this true? Broke Down how ??? Was the MIL Lamp on the dash & if so what codes did you have? What Year & what motor

...Engine stalls or RPM fluctuates at idle up and down. This problem is commonly caused by a dirty automatic idle speed control valve and throttle valve but always run a OBD2 fault code as well as ...

...Engine stall or RPM fluctuates at idle. This problem is commonly caused by a dirty automatic idle speed control valve and throttle valve. Buy a can of throttle valve cleaner (do not use carburetor ...

idle, but when I try to give it gas, the car dies. It will start again, but cannot accelerate. When was the last time you had your fuel filter replaced ?? Sounds like the engine may be starved for gas

...engine, hold the idle high so the engine won't stall, then spray the can of cleaner into the intake while keeping the engine running, use at least 1/2 the can, shut down the engine and disconnect the ...