2003 Acura 3.2CL "brake" Questions

soft brake pedal after rotor replacement I took my wife's 2003 3.2 CL to Pep Boys to install new front rotors and brake pads, and to adjust the parking brake cable. After picking up the car, the pedal

illuminated when emergency brake is not on. Check your brake fluid. there is a float switch in the resevoir that will turn on the light. will try to help. is brake master cylinder full of brake fluid?

? abs light is on, automatic transmission shifting problem There is also the chance that a piece of brake pad has broken and is jamming the brake, creating resistence that the engine must fight. 

which direction do i loosen the bolts on my calipers i tried both i need my brake pads off bolts and screws extract counter clock wise. as you are looking at the top of the bolt or screw, with the ...

both rear brake lights don't work, the third upper brake light does. Dash warning light illuminates to say brakes lights are out. i had the same problem  with a 99 acura cl  turns ...

Brake lights stays on even when the car is off, and is not the switch at pedal beacause it release the gear lever correctly. Try to adjust the brakes in the back to make the pedal rise, if it has drum

i have a holden statesman vr 1994 and have no brake lights. Fuse and bulbs all good ok fuse and bulbs are ok then you have to start looking at switches there is a switch on the arm of the brake pedal,

I have a 1998 Acura CL. Just changed the brake pads all the way around. Also had the brakes bled afterward. Brake pedal goes to the floor without thorough braking during stops. You need to bleed them ...

emergency brake the brake will not disengage fully. the light turns off but my car still feels like its being held back. brake cable is probly hanging up inside case that cable runs through. needs to ...

My car brakes lights was not working, i replaced it with new ones and it still did not came on , i checked all the fuses and found out that they were o.k. Can you please advise with further ...