2003 Suzuki Aerio "test relay fuse fan" Questions

...relay is bad. or the fan motor is bad. Or you have a blown fuse.Look for fuse first.... To test if fan motor is bad disconnect the connector to the fan and jumper it to the battery.if it spins ...

...relay,,,blower resister may have went all the way out take motor out and check with 12 volts directley to it really need to envest in a test light ground the test light ,and turn key on,,,touch both ...

...relay, fuse and engine temperature sensor's. Verify that the fans work by unplugging them and run jumper wires to the fan(s) from the battery. If they run, your problem lies elsewhere. If either ...

fuse or relay issue. the problem fixes itself everytime I schedule her to the shop. a lotta info, I know. With your overheating problem I would get a can of radiator clean and follow the directions on

...test the affected relay switch voltage supply circuit for a short to ground or an open/high resistance. If the circuit tests normal and its fuse is open, test all connected components and replace as ...

...relay, thermostat and wiring must be tested. If you have already replaced thermostat, test the rest. Check the fan fuse first. Most VW use a 30 Amp fuse located in the fuse plate. Refer to the car ...

...relay and thermostat are OK, then the fan motor is often the next test. The motor can be tested energizing it directly. Variable speed fans have more than two wires powering the motor. To avoid risk ...

...relay location for cooling fan. fuse is good, fan motor tested fine. need wiring schematic where is the circuit located for a 1994 ford taurus cooling fan? fuse is fine, fan motor tests fine need to ...

...test checks the fuse, relay, fan motor, wiring system ), if the fan runs it is the radiator stat. if the fan do't run then it may be the fuse, relay, wiring system. try replacing the fuse, relay. if ...

relay relays dont always go bad ck fan with jumper wires first and test ligt to see if power when a/c is on a/c overrides engine fan switch if wont work with a/c on then start cks  relay shoud be