1998 Plymouth Breeze "cross joint" Questions

...systems The drive shaft(rear wheel drive) or drive-axles (front wheel drive), transmission mount cross-member (rear wheel) shift rods or cable hydraulic lines (if automatic) inspection/access

...joint pin through the cross member is in a tight location, is tightly wedged into the cross member, and requires a special v-shaped puller to remove the pin from the cross member. If you don't have ...

...cross part of the old joint to force the cup out on opposite side. Repeat on all the cups, once you have the cups out clean all the rust and scale from the shaft bores. When you go to install the ...

...cross trainer approx 9months old. You need to isolate the noise by listening with a stethoscope, a sonoscope or something similar to discover which is the noisy joint (are you sure it is the machine ...

...JOINT REPAIR KIT WILL CONTAIN A NEW CROSS - SEALS - BEARINGS - CAPS AND SNAP RINGS.INSPECT THE BEARING CAP BORES IN THE YOKES FOR WEAR AND DAMAGE.IF THE BEARING CAP BORES IN THE YOKE ARE SO WORN THAT ...

...or splines in the case. The cv joint has to maintain the balls in the centre of the angle or they will bind up ( similar to a "U" joint) except that there balls instead of a cross and needle

...cross.The next step is to grab firmly either side of the joint and see if there is any movement while twisting you hands in opposite directions. next lift one half of the cross and check for movement ...

...joint or rust streaks coming out of the cross seals. The following are points that you have to be very careful off . The ears ( that part that holds the "U" joints) have to ne on the same plane on ...

the jimmy squeaks a lot when its moving....from the underneath of the car...? check for dry/ worn u-joints. check for rust streaks at the cross of the joint check front cv joints.

What is the 3 cross am bearing? I think this is the UNIVERSAL JOINT on the drive shaft .The English refers to it as the CROSS and BEARING because it looks like a cross.