...crank. to know where and what position it's in. The part is about $55 and it's located by the front of the transmission where it meets the engine block. Very easy to change. I've changed a few on ...
...fine but i was changing some fuses. then after i changed them my car didnt start and a mechanic checked my fuses and said they were fine. try the crank position sensor. the one on the bell ...
Question about Jeep Grand Cherokee
...fire. please help. engine code 54 shows up . cam shaft positioning no signal. . tested all circuit. changed cam shaft positioning sensor twice.still cranks did start once ran for 5 min. changed the ...
...ive replaced the cam position sensor, crank position sensor, coolant temp sensor, distributor cap and rotor with no changes to the dying issue. the jeep has 188k miles on it. Have the ECM
position sensor, coil pack/module and it still runs rough at idle. Almost like it is going to shut down but has stopped completely turning off since I replaced the CPS... looking for suggestions- IAC?
...crank position sensor? I replaced it with a factory one that I bought from Chrysler jeep, is there any other problem I should be looking at im out of ideas and almost money still bad. still
...help. Very intermitent problem but getting worse. Mine too.same year and make. O2 sensors changed,crank sensor changed,,"No Help. Had to 3 garages and Jeep service NO HELP just a lighter wallet. ...
crank position sensor, next in line would be the cam sensor. You could also have a bad fuel pump or pump relay. Crank sensor is on the bellhousing at about 11 o'clock looking from the rear. It is even
crank sensor check harness where it connects real good for damage or cuts,check and see if fuel pump comes on when the key is in the on position for 3 secs.make sure you have fuel at fuel rail . Check
1,568 questions posted
Usually answered in minutes!
3,350 Questions
3,279 Questions
2,899 Questions
2,715 Questions
2,521 Questions
