1996 Jeep Grand Cherokee "removing head 3" Questions

Ad

3, 6, 2, and 10 You're supposed to use old bolts with the head cut off, (Alignment Dowels), in bolt holes 8 and 10. This way you goop the gasket, and install it, then slide the head on. Place the head

Ad

Question about Jeep Grand Cherokee

2 Answers

...at cilinder head ,fan motor,( those are the most comon causes ) Good Luck replace cooling fan relay. it is located under the passager head light underneath the blk surface. Make a 3"x3" to remove

Ad

Question about Jeep Grand Cherokee

1 Answer

replacing left front door First, disconect batttery. 2-remove the door trim panel,3-disconect any harness wiring.,4-place a jack under the door or have an assistance(is heavy),5-remove the ...

...3 flat chrome colored contacts on the assembly. 5) Notice the one by it self at the top of the opening, that is the "ground". 6) If you look closely you will notice the plastic around the ground ...

Question about Jeep Grand Cherokee

1 Answer

...3 flat chrome colored contacts on the assembly. 5) Notice the one by it self at the top of the opening, that is the "ground". 6) If you look closely you will notice the plastic around the ground ...

Question about Jeep Grand Cherokee

1 Answer

...head light.....you have to remove the grill and remove the passenger side of the front nose cover....pain in the ****.....simple way...remove passenger headlight and cut a 3 inch circle out of the ...

Question about Jeep Grand Cherokee

2 Answers

...head of the bolt is turned 1/3 of a turn each time and reset. You might have to put 2 wrenches together for the torque required to remove the bolts...the back nuts are welded to the frame and do not ...

Question about Jeep Grand Cherokee

1 Answer

3.1l diesel. What is the correct head gasket? there are three thicknesses available no year? Jeep? one post, and no year.
is this WG jeep say in europe. ? we dont have WG here.
WG started in ...

...3 look different to the others. Look at the plug connectors carefully to see if there are signs of shorting through the insulator to the cylinder head. Check the resistances of the high tension lines ...

Question about Jeep Grand Cherokee

1 Answer

...light once removed (to make sure that it is the right screw it is about 3 inches in length) and then you have to pull quite hard on the head light to remove it, once out remove electrical

Not finding what you are looking for?
1996 Jeep Grand Cherokee Logo

4,552 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Jeep Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...