1996 Jeep Grand Cherokee "caus knock tune" Questions

Ad

Question about Jeep Grand Cherokee

1 Answer

...happens under load. 1: check fuses. 2: check knock sensor for outside damage. 3: SCAN the PCM. do you have any DTC errors/ 4: do a full 60k tune up. maybe its lean because the fuel filter is

Ad

Question about Jeep Grand Cherokee

1 Answer

...that correspond to its center frequency (5550 Hz). Vibrations from engine knock (detonation) cause the crystal inside the sensor to vibrate and produce an electrical signal that is used by the ...

Ad

Question about Jeep Grand Cherokee

3 Answers

...tune the engine so that it doesn't knock. If your knock sensor wasn't operating properly, so that it was always indicating a knock, the engine computer's response may have been to change the ignition ...

Question about Jeep Grand Cherokee

1 Answer

tune-up would be good too. Spark knock or preignition sometimes is caused by carbon build-up in the combustion chambers. Other knocking might be something physically bumping, like a loose exhaust pipe

Question about Jeep Grand Cherokee

1 Answer

...Tune up or fuel filter can cause the code to set for the knock sensor. It listens for knocking so the pcm can shut the car down. Those very rarely go bad unless it has been soaking in coolant

...gas .make sure engine timing is correct. also make egr valve is opening when it suppose to it will cause detonation.you will need a scanner to check tps and egr

I have a 96 infiniti i30 and while im driving there is a knocking noise... what this be? The check engine light is off. I'm not familiar with this car, but your gasoline may be too low in octane, that

Question about Jeep Grand Cherokee

1 Answer

...knock sensor. Check the connector. Sometimes just disconnecting and reconnecting fixes the fault. Otherwise, it is not difficult to replace. It is a round gizmo attached to the block with a bolt ...

Question about Jeep Grand Cherokee

1 Answer

knock" sound during engine rotation. "Pinging" refers to the tapping sound you get upon acceleration, either when using fuel that is to loo octane for the vehicle, or when static timing is set too far

Question about Cars & Trucks

1 Answer

...tune the engine so that it doesn't knock. If your knock sensor wasn't operating properly, so that it was always indicating a knock, the engine computer's response may have been to change the ignition ...

Not finding what you are looking for?
1996 Jeep Grand Cherokee Logo

4,552 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Jeep Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...