1996 Jeep Grand Cherokee "burp car engine putting water" Questions

Ad

...burp' the water jacket. That simply means letting the car idle to operating temperature, at which time the coolant will start to circulate. You can see it begin to rush past when you look into the ...

Ad

...engine overheat, is top issue. id you fill it correctly with 50% antifreeze the burp out all the air? that is what above air lock means as does air pockets. all air out of system (read a book on ...

Ad

Question about Jeep Grand Cherokee

2 Answers

...car runs and heats up, the coolant will begin to flow through the system. This will make the air bubble also flow through the system. Once the bubble (or sometimes bubbles) reach the open radiator ...

Question about Jeep Grand Cherokee

1 Answer

...burp the radiator. This is easy to do. Jack up the vehicle so that the thermostat is angled upward. Start the car and let it idle until it's 3/4 of the way to overheating, then shut it off and allow ...

...engine off for sure !!! at first fill. 5: burp it so no air remains in the system this is the key part and most hard for all those never done the before. do so completely i can now write a wall of ...

Question about Jeep Grand Cherokee

1 Answer

engine. and 1/2 million miles. Drain coolant , same chapter. see top FAT RAD hose? (of 2 hoses big , its the top one) follow it to the THERMOstat housing , unbolt it, BAM the thermosat fell out. watch

Question about Jeep Grand Cherokee

2 Answers

...engine warm up so the thermostat opens and allow thw air to escape through the rad. top up radiator as required during this burping procedure. Once all the air is out top up the rad again and put the ...

Question about Jeep Grand Cherokee

6 Answers

...car has been offroad (on sand) once, and was never reliable enough for me to take it off road again. Sell it my friend, I seriously do not want you to go through what I have. Have you checked the ...

engine at operating temp. Installed homade burp VALVE right after heater core outlet(high part of hose). Still no heat. Removed water pump, impeller still in good shape not stripped off shaft. Removed

engine to burp) put back STAT cover with sealant/gasket or with 0-ring , depends on engines size, not stated. fill system. Rad cap hole, till full. run engine 1min, stop check fill repeat. burp system

Not finding what you are looking for?
1996 Jeep Grand Cherokee Logo

4,552 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Jeep Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...