1995 Jeep Wrangler "shift linkage adjustment" Questions

Ad

...Shift Solenoid" installed in tranny. Take it to a Jeep dealer to have it verified by computer diagnostic which usually runs around $30.00. check linkage and lines look for a vacuum hose going to the ...

Ad

Question about Jeep Wrangler

1 Answer

linkage rod slid out of adjustment or came off and you can re-adjust or re - connect it. The setup in my cherokee is pretty much the same as yours and it tends to bind going into low (there is nothing

Ad

...adjusted with wrenches. If clutch is fine, It could be a loose shift linkage. It would seem extra sloppy when moving shifter, It would just not go in gear, with out the grinding.Hope this helps. ...

Question about Jeep Wrangler

1 Answer

...to push the clutch all the way to the floor to shift gears and downshift. Is this a simple problem or does everything need to be replaced??? look at the linkage on the pedel se if you can adjust ...

Question about Jeep Wrangler

1 Answer

shift linkage adjustment. Raise and support the front end on jackstands. Place a drain pan under the switch. Unscrew the switch from the transmission. Replace the switch, using a new seal. Tighten the

...shift gears? Clutch doesn't seem to disengage to allow shifting. might have air and may need to be bleed cable or linkage damaged or require adjustment or clutch burnt out needs replacement wow no ...

Question about Jeep Wrangler

3 Answers

...shift linkage. if it works in all gears but second the clutch is working. your problem is most likley spline wear where the hub slides on the mainshaft for second gear some times they wear a notch in ...

Question about Jeep Wrangler

1 Answer

...shift linkage problem. Possibly synchro forks are sliding back and forth on shift rails and are out of adjustment. This is internal and cannot readily be fixed without trans removal as far as I know. ...

Question about Jeep Wrangler

3 Answers

...shift it into neutral, and try to start it. It is easy for the linkage to get out of adjustment, where it thinks the jeep is in gear. If that does not work, make sure you have battery power to the ...

Question about Jeep Wrangler

2 Answers

...linkage, I'd say that was it. The problem may be related though. Does the shift lever feel loose? Same shifting problems when trying reverse? With the engine off do the same shifting problems exist? ...

Not finding what you are looking for?
1995 Jeep Wrangler Logo

893 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Jeep Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...