1995 Jeep Wrangler "air hydraulic clutch system" Questions

...hydraulic clutch and the petal went to the floor today, I assume the clutch went out the first thing that i would check is the fluid level in the clutch master cylinder. It is just like the brake ...

...air in the hydraulic system, sometimes there is a funky bleeding routine. I hade a Ford Ranger and you had to pump up the clutch master cylinder before connecting it to the slave cylinder, it took a ...

...hydraulic clutch). You may need to bleed the system. With air in the system, you can't get enough clutch to fully disengage the trans from the motor.(Clutch and pressure plate) It's like you only ...

...hydraulic, and self adjusting, there are several things that can go wrong with these. with normal wear the fluid can run low allowing air into the system, causing a weak peddle. they can also develop ...

clutch hydraulics have gone out. check your fluid level. if low you may have sucked some air into your system. you will have to bleed the lines as you would for car brakes. The other possibilities are

hydraulic, check the clutch master cylinder for proper fluid level. If out or nearly so, look for signs of fluid leakage around the master cylinder, the hose down to the clutch slave cylinder, and the

hydraulic line from the Master Clutch cylinder down to the slave cylinder by the transmission. The bleeder valve should be on the passenger side of the transmission if you have a 4 cylnder and drivers

...air out of the hydraulic clutch slave cylinder bleed it for over an hour goes in to gear fine then will start grinding any help on the best way to bleed it This is not a complex system. If air is ...

...Hydraulic systems should compensate somewhat, but if you are beyond the travel of the slave cyl, I'm not sure there is anything you can do from the outside. I would check that there are no air leaks. ...

...air in the hydraulic system, faulty slave cylinder or faulty clutch master cylinder unless you have oil on the clutch plate causing it to stick or a dry or seizing spigot bearing in the flywheel( ...