1989 Jeep Wrangler "ignition switch problems" Questions

...ignition switch. To find out for sure, remove the plastic covers over the steering column and remove the 2 screws holding the ignition switch in place. Make sure the mechanism coming from the key is ...

ignition switch! If it can't be pull out, the problem would be the ignition switch have to be replace, 'cause of eroded copper/brass pins inside the switch! The problem of ignition switch key pull out

...is turned. The problem is in your ignition switch. The ignition switch is in the steering column. It is just inside or under the dash. The ignition switch is not sending power to the starter

...ignition switch voltage should drop to about 0.4 to 0.5volts and the switch status should show start/crank. If the ignition switch status shows FF, that is an undermined switch status. The ignition ...

...Ignition switch, ignition Module, Ignition Coil, or distributer. I pulled the spark plug, and got not spark. I checked the lead wire into the ignition coil and the light lit up. I was told that if it ...

ignition switch on 1997 jeep wangler wont start Wells Jeep/Chrysler Ignition Switch Replacement LS711 LS922 ... https://www.youtube.com > watch I had the same problem but I just went to where I bought

...ignition switch will work properly again (even if you are able to get the key back to off and the accessories turn off) is to replace the switch. I hope you found this solution to solve your problem ...

The ignition switch is probably too full of metal filings from the keys and worn parts. Try flooding the switch with WD-40 to flush it out! It sounds like to me you have a bad key and tumbler assembly

...switch is connecter to the ignition this is why its killing the engine . This should be repaired as quickly as possibale there is a lot of amparage on the ignition ciruiut and could cause a fire . ...

...ignition switch is stuck in the off position and i mean stuck. The key goes in all the way with no problum but the switch will not turn keeping the stering wheel and gearshifter locked. so what i am ...