1989 Jeep Cherokee "wont 1st gear" Questions

wont shift so I have to shift it manually its an automatic so i put it on 1st and as it gains speed I shift up to a higher gear. does anybody know if the TPS would fix my problem? sounds like it could

...1st? We got the jeep stuck and hydro locked the vehical. We were not able to get it started at first, so we pulled the plugs changed all of the that, cleaned the distrubutor cap. We dried everything, ...

...1st-2nd and wont shift to 3rd almost like stuck in passing gear. when hot shifts great no problems. shifts in all gears . afraid going to blow up motor or blow gaskets thanks craig Sometimes you ...

...wont go into gear, bring up the clutch, press down again and retry - the clutch isn't fully disengaging and 1st gear is not on synchro so it's pretty much impossible to slot it in if the input shaft ...

...wont shift out of 1st gear. I have reverse also. worked fine never had any problems then i parked and went into store and came out and car wouldnt shift. I tried low range and it didnt help. checked ...

...wont shift fron 1st gear the transmission was just rebuild but wont shift from 1st gear up it was taken down again double check replace turbine put back on and still wont go trough gears other than ...

wont change from 1st to 2nd gear please help went to go up a hill and wont move out of 1st gear just screaming have 1st and reverse gear only may have to replace the transmission shift solenoids. Some

...to second gear there are only 3 issues here. 1 weak engine, , even 1st gear I have no engine power. 2: 1st revs normal but wont shift up. 3: the transmission slips. (flares) RPM goes nuts. which

wont go againg in 1st gear, just will make noise and if you play a little it will catch 1st gear again. Diagnostic wont give any code,also the fluid was clear after pan was removed, transmission fluid

...wont kickback to any gear but 1st.If the shifter is in low it wont go into 2nd it just holds 1st when the shifter position low shows 1st and 2nd. the oil is not burnt or low and i cant get it to slip ...