...set timing correctly, then put both a vacuum gauge and tach on the engine. adjust one idle screw to highest vacuum reading and highest tach reading, then do the other one. go back to the first and ...
...highest reading Have to reset the idle screw & recheck your timing without vacuum advance hooked up. If you can find any specs, you can use them They most likely will use rpm as the setting ...
...set the throttle positioner and it seems to be functioning properly. I replaced the idle air control valve and checked voltage and function and it checked good, however while the engine was running I ...
...idle speed with linkage adjustment. If they used a spray to clean the carb, then all the junk that was in the carb burned off on your plugs. You probably got a lot of black smoke out of the exhaust ...
...set the throttle linkage adjustment screw so that you have the lowest possible idle without stalling and then put a hand held tach and vaqcuum gauge on the engine (you can use one or the other but ...
...set mixture of fuel and air on my carburetor Would be nice to have the year and engine size to verify you actually have a carb and not injection, but, to adjust most carbs, disconnect and plug the ...
...set and idle at a really really low rpm, the oil gauge will drop to around 210 degrees F and just stay there but as soon as I start moving and just driving a very short distance without pushing any ...
...set it and what is the best way of cleaning out the carby without removing it from inlet manifold?i am an exhaust fitter by trade but this is not my scene so any help would be greatly appreciated ...
266 questions posted
Usually answered in minutes!
635 Questions
545 Questions
532 Questions
469 Questions
339 Questions