1987 Jeep Wrangler "control module location" Questions

...OF IGNITION CONTROL MODULE ON 1987 JEEP WRANGLER 6CYL Hi!!The Control Module-Ignition is located:Under hood, passenger side, upper engine area, mounted on firewall Don't forget to rate this

where is the ignition control module located Jeep did not have a ignition control module for either engine this year. Are you sure you this is the name of the component your looking for?

...regulating circuit located within the Power train Control Module (PCM). The EVR is not serviced separately. If replacement is necessary, the PCM must be replaced. Hope this helped and best

...computer? there are a few but i think you mean the PCM or Powertrain control module. that is bolted to the firewall behind the battery He's right. It's a silver square box that's behind the

...control module (if you have one it is located next to coil). Most common of these is failure of crank sensor. BUT, check before replacing. 'Won't hurt to buy a manual to guide you through

...control module and/or the ignition coil. Often an ignition sytem thas two wires connected to the run terminal of the ignition switch. On is connected to the module. The other is connected to the ...

...control module. 4 screw/nuts allow you to pull out your climate module box. Check your connections. Most likely, your selector switch is melted. Perhaps even the harness that plugs into it is melted ...

...control module before this all started. check out the crank position sensor,if its bad it wont give any spark to the plugs.on the 4.0 models it located in the trans bell housing on the drivers side ...

...the hood approx 6 by 8 inch flat box shaped. Go to auto store and they can show you a pic of it. It Controls Spark plug Firing. hope that ...

...Control Module. Where is it located? The manual shows it next to the battery but it's not there. Ignition control module does not control everything electrical. check battery connections at both ends ...