1985 Jeep Cherokee "remove 95 transfer case" Questions

...95 jeep cherokee laredo Is it a an 85 or a95? I know of two switches on these vehicles, one is a four port vacuum switch on the top of the transfer case, you must unplug the vacuum line, and unscrew ...

95 jeep cherokee behide a motothome Yes u can but you should remove one or both driveshafts. you can unlock your front hubs if they come with manual front locking hubs. and  put the transfer

...remove oil pan, but the transfer case is in the way of get bolt out, how or what do you have to do to get the oil pan off 1997 blazer 4x4 I;m doing the same on a 4x4 95 yukon. I used a 1/4 drive deep ...

...95 model year Jeep Grand Cherokee. You should be able to identify the switch easily enough. There is another switch that is easier to get to located between the transfer case and the forward drive ...

95 gmc suburban 4wd in 2w actuator had shorted cabling and was replaced . now the truck will go into 4w and the hubs will lock. no noise in this arrangement but if we go back to 2w drive then we get a

...transfer case on a 95 dodge 1500 to get stuck in low range The best solution you'll get from books at www.reliable-store.com These are books containing info on repair, service, troubleshooting, parts ...

...95 dodge ram 1500. I can engage the fransfer case by using the floor shifter to 4hi and 4low, but i jacked the front driver tire off the ground and can spin it with my hand. Any ideas what is wrong? ...

...95 Grand Cherokee limted. I have a humming noise coming from the front end it gets louder as i accelerate, when I let off the gas the humming sound dies down. I was told it could possibly be my ...

...95 isuzu trooper with the 3.2l engine 4x4. Im not to smart about the inside of them, does the 4L30e have tranny bolts th hold the housing to tranny I need a diagram of the 4L30E TRANSMISSION so i can ...

...95 dodge 3500 4x4 service truck when u put it in 4wheel drive it seems like something binds and then pops and then it will roll again im thinking maybe the pinion bearing because i replaced both u ...