...or right, you should see the wires going to the light. There will be a connector holding the bulb in place. Remove the buld by turning it right or left to release. Good luck and don't forget to
changing the headlights how do you change the headlights? Try not to touch the buld as you do the installation. There is a access cover in the back of the head lamp. This gives you access to the ...
...buld low beam. Didn't work right so I switch bulds right to left still only the left drivers side headlight won't come right on. Sometimes if I turn light on and off a couple times the left driver ...
2004 ford e150 brake lights not getting my brake lights to work everything else works turn signal hazzard running light change bulds and brake light switch do you have voltage at the brake light ...
Question about Honda Odyssey
buld in a 2001 pontiac azte how do you change a turn signal bulb? open tail gate area and you will see 2 screws that come in to the light from the side,remove screws and pull light out to replace bulb
HID Headlight not working, changed buld still not working. Thank you. you will have to change the ballast for this type of light to work
...light 1. Never touch the lamp glass with bear hands 2. Visual inspect the connector 3. With a multimeter check the voltage on the connector 3.1 If you have aroubd 12 VDC cabling is ok and you need a ...
changed parking light buld but still flashes fast and wont come on when I turn the lights on sounds like a bad ground some where
all lights turn on, exept backup lights i change fuses an bulds I would look at the back up switch, located at the back of the transmission. its a 2 wire piece kinda round on the top looking.
Question about Honda Odyssey
i have no brake light on my chrysler 300c 2005 fuse ok, relais ok, and swich ok. brake light is not working i change the fuse and the relai and brake swich on the brake pedal CHECK THE BULD
748 questions posted
Usually answered in minutes!
578 Questions
521 Questions
449 Questions
472 Questions
460 Questions