2002 Chrysler Concorde "replacing number 3 valve 2004" Questions

...3 years!! I was told by the mechanics that it could be the gas, corrosion on the check engine sensor, the gas tank cap, or it was just a "stored code" that could be reset. In the end the transmission ...

...3 shift solenoid located on the 2004 pontiac montana and how much is the replacement part and repair job The solenoid is inside the valve body, If you remove the pan, the filter, you are looking at ...

...number of LF62 13 100J. However, I cannot locate the part on the Internet. If you can help, I would greatly appreciate it! Clickety clank in Long Beach, CA Thanks, Dennis I have had the same problem ...

...number 3 plug not firing changed some plugs a round didn't help the pipe after the cat conver with oxygen senser gets cherry reg if you rev up motor.could the coil pack have some thing to do with ...

...number 2 and 3 simultaneously. Center pin is 12 V supply and the left most is switching signal wire for cylinder number 1 and 4 simultaneously. Now the problem may lie in: - The high tension cords. - ...

number (VIN) range: 3 DR: Produced through KMHCF35C63U235415 4 DR: Produced through KMHCG45C03U412818 The problem is you will have to take it to the dealer to get the reprogram done. P2096 - Fuel trim

replacing a cylinder head, it is critical to tighten the head bolts using the proper torque (tightness) specifications and pattern. For example, cylinder head bolts for a 2004 Ford Crown Victoria 4.6L

number of different causes. The fuel tank is the least likely cause of this condition. The following Diagnostic procedure can be used to diagnose the issues. DIAGNOSIS: 1. Is the vehicle a LX/LE/LC/L2

...3 cylinders, and 180 lbs in the last. But could be from no fuel. Cleared code with scanner and even removed positive terminal from battery 15 minutes. Completely stomped. Car has 124k. New plugs, New ...

...3.2L 6cyl 6AM) stalled on me at a red light, In February of 08 the car stalled on me at a red light, and the check engine light came on. I had to put the car in PARK to start it again. Several times ...