2002 Chrysler 300M "rear brake" Questions

...wheels are 15-20 cm (6-8 in.) off shop floor. Release park brake foot pedal and verify that rear wheels rotate freely without drag. Verify pedal returns to fully released position. Lower the ...

rear disc brakes Brake flex hose from the support bracket and wheel cylinder, if equipped with rear drum brakes. Plug the brake flex hose to prevent system contamination. Do not allow the rear caliper

Thumping sound in rear wheels on turns or when braking downhill The rear wheels make a thumping or dull sound of balls rolling around on turns or braking going downhill. Just had new brakes and rotors

...BRAKE PEDAL ON 4 WHEEL DISK BRAKES I BOUGHT A 2007 CHEVY TRAILBLAZER ON 5-5-09. THE PEDAL GOES DOWN ABOUT HALF WAY TO THE FLOOR AND FEELS A LITTLE SPONGY. I THOUGHT I COULD GET THE REAR WHEEL DRUM ...

...brake rotors are warped and upon replacement the lug nuts should be torqued to 100 ft lbs or they might warp again,also the rear brakes should be checked for correct operation to make sure all the ...

...then you will have to check the wiring from the brake switch back to the rear lights.another thing is does the signals work at the back if they do then the signal switch is eliminated as a

...rear suspension with stabilzer bar independent with coil spring? 8. Coefficient of drag 0.31? This car 1999 300M has other features which I know how to use and I have always wanted this car but feel ...

...rear brake rotors i know the rotors are bad they just wont come off It's pretty common for rotors to seize up on the hub. Spray the middle hole of the rotor/hub with penetrating oil (WD 40, etc.) and ...

brake pedal is depressed the White/Tan wire should be hot. From there it goes to the Stop lamps. You dont say if the high mounted stop lamp works or not ( I ASSUME not??? working) You say the bulb was

what tools are required to replace both front and rear brake pads on 2002 chrysler 300m special small set of metric wrenches/ sockets. and a "c" clamp to compress calipers