2001 Chrysler LHS "transmission lines leak radiator" Questions

it's oil and not transmission fluid. Some vehicles have tranny cooling lines running thru the radiator core. Have seen some lines get small pin holes in them and leak the fluid into the cooling system

...transmission cooler lines are attached to the bottom of the radiator. If it is the transmission cooler line leaking, simply replace the line from the radiator to the transmission with 1/2 inch ...

...lines that run from transmission to a separate reservoir in the radiator, or leaking from the reservoir itself. Hopefully, it's only the lines and may just need tightening to stop the leak.There ...

...transmission lines (one in, bottom and one out, top) could be leaking from the cooling system. Bring your vehicle in for a cooling system pressure check. Another thing to keep in mind when inspecting ...

...transmission lines. There should be two lines, one on top which is the inlet and the bottom one which is the return line. Check to make sure there is no corrosion along the lines or that the line has ...

transmission line but the fluid is so coarse I cannot tell which line its coming from. Its leaking from one of the lines under the radiator. It only leaks when I start the car up and its at idle, when

...transmission and engine oil cooler lines to it too. One of the oil lines are leaking, if you know which one that's have the battle. I believe the transmission line is on the passenger sides and the ...

...radiator,does it Transmission line leaking at radiator,does it need an O"ring ? Replace fitting that screw into radiator, do one at a time, dealer will have this part also radiator shop's cost about ...

transmission. Could I possibly have the lines cross? Or could the new radiator be defective? Crossing the lines would not cause a leak. i think you need to take a good look at the lines and see if its

...transmission lines are leaking at radiator Do you know if the leaks are coming from the actual lines or the fittings to where these transmission lines connect to ? If it's the fittings, you may need ...