...timing covers and rotate the engine so that the crankshaft sprocket is at top dead center and the two camshaft sprocket marks line up in between the pair of marks on the rear timing cover. (Do not ...
engine over, then check timing with timing light...and adjust accordingly... Nothing to do with cracks yaddi yadda. The belt on a 1992 Chrysler 3.3 V6 of almost ant denomination will come off if water
...engine. The main sensor responsible for the timing is the CAM Position Sensor. This isn't the only sensor, just the main one. It is found on the top front of the engine, right near the coolant ...
...timing in the all engine move , if that happen how can i fixed. Align the camshaft sprockets between the marks on the covers,behind pulley's Align the crankshaft sprocket with the TDC mark on the oil ...
...nw yorker 3.8 v6 runs good then just dies wont start and stay runing until 5 to 20 min. pass.check engine light not on all time but its worse when it is. If you turn the ignition on and off 3 times ...
engine won't start. I used quick start fluid into the intake. It fires up as long as I'm spraying the quick start, but stops when I stop spraying. The engine was running fine, and although the car is ...
...timing belt. Engine started great when it was still torn apart. Ran smooth. Put it all back together, and now it won't start. rechecked timing, spot on. Has fuel but no spark. Checked all fusses. Any ...
Question about Chrysler New Yorker
...timing marks align. This is most important. An engine out-of-time will be seriously damaged when first started. Be sure that the radiator drain is closed. Open the thermostat bleed valve. Install a ...
...yorker is skipping. Could this be the timing mechanism? Yes this can be a skipped timing belt or chain.......depending on the engine size. It may also be a fouled or worn out spark plug or plug
118 questions posted
Usually answered in minutes!
156 Questions
147 Questions
162 Questions
127 Questions
111 Questions