...hard, may have a code p1811 set-trans adapt long shift. When this code sets it commands full line pressure causing hard shifts. Usually the pressure control solenoid is at fault. You need to have it ...
Question about Mazda MAZDA3
...shift, it goes out uf gear and the engine revs as if in neutral. At this point I let up on the accelerator and after engine speed goes close to idle, it shifts hard to 3rd. Similarly, when you press ...
that causes a hard shift from 1-2. Stop by an Auto Parts store that has an OBD scanner and reset any codes. If that doesn't work, change the tranny fluid and filter and try SeaFoam additive. Good Luck
hyundai accent won't move in reverse. It can go foward just fine. on a hyundai you have a shifting sensor attached to the transmission that if it starts to go bad it will cause many problems, hard ...
Question about Mazda MAZDA3
...hard when it shifts sometimes( Usually shifts normally) but if i turn the car off when it does this it will reset and shift normal again? fluid dirty -need filter change --valve sticking --clutches ...
Question about Mazda MAZDA3
...and what could cause it to come on? thanks Alex The shift solenoid tells your vehicle when to shift. They are not very expensive or hard to fix. They are located under the transmission filter ...
...shift hard every time I get on a highway and come back to street traffic. I replace all 4 solenoids on the transmission and the problem still. can someone help me find out what is happening. thanks ...
Question about Mazda MAZDA3
hard shift was the result. In your case the engine isn't producing the correct amount of power due to the misfire at part throttle which could delay and harshen the shifts. While 'getting on it' would
Question about Hyundai Cars & Trucks
...hard but not as bad light came back on codes p0700 p0722 code p0700 is TCM problem code p 0722 is output shaft speed sensor--no signal===causes --wiring--OSS sensor --TCM ---ECM possible that your ...
...Is the car running good? If the motor isnt running right and is missing with no power it will cause the transmission to shift hard due to taking to long to shift, so it could just need a tune ...
636 questions posted
Usually answered in minutes!
375 Questions
370 Questions
157 Questions
30 Questions
18 Questions