...sounds like the horn itself has failed (still check wiring ) the best way is to ground the horn and provide power if horn sounds it is ok if not horn is bad otherwise further diag required start ...
...horn are not working..2005 mazda 3. Need schematic of wire system I have a mazda b 2200 truck and the fuse for the horn and the brake lights share the same fuse.check the fuse for it under your
...horn still did not work. After a 16 mile drive, the noise started again and I realized that the brake lights stopped working and I was stuck after putting it in park. Could this be a wiring problem? ...
...horn fuse to be slot 21 in the engine fuse block (not the fuse block in car interior). Replaced 15A fuse and all now ok. when you press the brake, do you hear any relays clicking? With that many ...
...3. began one day at getting new brakes. as the mechanic drove it in the shop and parked it all of sudden the horn goes off and wont turn off the headlights are flashing its going hay wire all over. ...
...horn stuck on solid. Since it dried out? the problems slowly went away. Now today, with no rain, my left turn signal wont shut off even when the car is off. and the right stays lit solid! Help! u ...
Question about Cars & Trucks
...Using the relay supplied, connectin pin 1 to 3 and 3 to constant 12v. Connect 2 to horn wire and 4 to + on the compressor. Negative on compressor to ground, and horn goes off? Not sure what to ...
Question about Mazda MAZDA3
...horn contact. Both r OK. Ohm checked the 3 wire harness that runs down the steering column. All 3 wires r OK. Tested both horns directly with 12v. Both r OK. Disconnected 8 pin connector above horns ...
Question about Chrysler Cars & Trucks
3.HORN RELAY CONTROL CIRCUIT X3 SHORTING TO GROUND INSIDE STEERING WHEEL.4. PINCHED HORN SWITCH WIRE UNDER DRIVER AIRBAG MODULE.5. DEFECTIVE HORN SWITCH 1. REFER TO HORN RELAY TEST.2. CHECK HORN RELAY
Question about Cars & Trucks
go to harborfreight or parts store and buy a new one, ifr the horn does sound than take off panel on steering wheel,3 screws behid wheel and look for wire to be pluged in and check the grounding wire
636 questions posted
Usually answered in minutes!
375 Questions
370 Questions
157 Questions
30 Questions
18 Questions