...throttle. Now I can't turn it on. The problem is with the PCM (Powertrain Control Module). It made be malfunctioning or may just need to be reset (disconnecting and reconnecting the battery). If it ...
control module (PCM) supplies a 5 Volt reference signal to the throttle position sensor (TPS) and usually a ground also. A general measurement is: at idle = .5 Volts; full throttle = 4.5 Volts. If the
control module (PCM) supplies a 5 Volt reference signal to the throttle position sensor (TPS) and usually a ground also. A general measurement is: at idle = .5 Volts; full throttle = 4.5 Volts. If the
Question about Jeep Grand Cherokee
Throttle position sensor input below minimum acceptable voltage. 25** A shorted condition detected in one or more of the idle air control motor circuits. 27* Injector #1 output driver does not respond
...control valve (IAC) valve. -Throttle motor. -Throttle valve tight/sticking. -Engine control module (ECM). Error Code: P0100 Fault Location: -Mass Air Flow (MAF) Sensor/Volume Air Flow (VAF) Sensor - ...
Question about Jeep Grand Cherokee
...Control Module (PCM) and Electronic Throttle System (ETS) unit. Using this communication line, various data, such as throttle target angle, TPS output, APS output and diagnostic trouble codes ...
Throttle Control My 2003 Dodge Ram 5.7L Hemi has been experiencing problems with the Electronic Throttle Control or ETC. Error codes displayed are 2106 and 2108. The vehicle loses power at accelerator
Question about Cars & Trucks
...throttle control . It should be noted that the ETC system illuminates a powertrain malfunction indicator (wrench) on the instrument cluster when a concern is present. Concerns are accompanied by ...
...Throttle Control (ETC) in this section. It should be noted that the ETC system includes a warning indicator, wrench warning indicator, on the instrument cluster that illuminates when a concern is ...
...throttle actuator control module. APP sensor A is for the primary control, and APP sensor B is a back-up of APP sensor A in case it malfunctions. Both sensors compare their output voltage to each ...
961 questions posted
Usually answered in minutes!
3,350 Questions
3,279 Questions
2,899 Questions
2,715 Questions
2,521 Questions