2005 Jeep Liberty "pay replace drive belt" Questions

belt cost? and what could I expect to pay the mechanic on a 2002 Kia Rio Cino The timing belt is not the big cost,if the belt has broken while you where driving the car the you may need to spend up to

How much can i expect to pay for a drive belt replacement on my 2003 mini the belt is cheap but putting it on is tricky as there isnt much room between engine and body of car

...replace it you will take a ratchet (usually a half inch drive) and remove the tension on the belt by placing the ratchet into the belt tensior pully. Once tension is removed you slip the belt off and ...

...replace the head gasket (or have it replaced). Pay attention if you do it yourself. Change the timing belt, water pump, and accessory drive belts when you do it. Be sure to align timing correctly and ...

...crank shaft, timing etc. besides any damage sustained if/when I throw the belt again. I got stuck paying dealer for new crank pulley not harmonic balancer as mechanic said. I am driving as little

...replace Thermostat, Thermostat Gasket, Timing Belt, Water Pump, Camseals Kit, Crankseal, Air Filter, Fuel Filter, Timing Component and Spark Plugs for a total of $981.24 ($510 of it is labor). He ...

...drive belt and check each pulley by hand for drag, or noise. Usually noises from the serpentine belt area are from the tensioner pulley, but since you installed a new PS pump I'd pay particular ...

...replace the timing belt on both the Ferrari 308 and 328 will run about $3,000. The Ferrari 348 will cost a bit more at $4,000. No Ferrari is inexpensive to maintain. However, the 308 and 328 will be ...

...pay $7000 to repair his engine because his timing belt snapped. I just got my timing belt replace yesterday. If you drive you car really hard or just hard, you should get it done at 60,000. IF not go ...

...replace belt properly find the belt tension on the truck it will take either a 1/2 inch drive breaker bar or a 15mm,17mm wrench connect to the tensioner pull it to the driver side to release the ...