...harness to 3 prong electric cooling fan? If so how The 3 pin fan is basically a 2 speed fan- it has a slower fan speed for aircon and a faster speed for engine cooling. Check the wiring on the fan- ...
Question about Jeep Liberty
...fan is? Lay down on the passenger floor and it's right there. Unplug the harness and remove 3 screws. You can also attach a small tube to your shop vac and snake it in there once the motor is out of ...
...fan relay blew, along eith the harness. Chec and see if the cooling fan kicks on and cycles after a few minutes of running with the a/c on. If it doesn't, it is probably the relay not kicking it on. ...
Fan Speed Control Resistor, and is located behind the glove box. It is simple to remove, the hardest part is disconnecting the wire harness. The part is like 25 bucks, and is sure to fix your problem.
...harness. It is held on the structure by either two rivets or screws. The structure acts as a heatsink for the relay to disapate heat. The rivets break allowing the relay to pull away from the ...
...fan housing (looks round and black in color. Then locate the resistor it will be in that housing usually withtwo ten millimeter nuts or two simple screws holding it in. unplug the harness to the ...
...bolts tighten bolts to 89 in-lb (10 Nm). Connect fan motor wire connector to harness connector, and attach connector to shroud. Connect negative battery cable. Start engine and check fan
Question about Jeep Liberty
...harness connected to the fan, it comes on. Notice the middle wire is extreamly hot compared to the two next to it is it the connector or something else could be relay but I'm thinking your lines ...
...fan inside my jeep only works on high what do i need to replace. when i operate my air conditioner or heater only the high speed works and none of the other speed work. It's the resistor pack. It's a ...
1,317 questions posted
Usually answered in minutes!
1,658 Questions
768 Questions
735 Questions
633 Questions
207 Questions